Table of Contents
Advertisement
UNIT OPERATION
Auto Mode
1) Install the exhaust hose and window kit properly (see pages 7&8).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER button.
4) Press the MODE button until the Auto mode indicator lights up on the control panel display.
Auto Mode will operate the unit in air conditioning mode when the temperature is above 72 degrees, Fan
mode when the temperature is below 72 degrees.
Sleep Mode
1) Install the exhaust hose and window kit properly (see pages 7&8).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER button on the control panel.
4) Press the MODE button until the sleep mode indicator lights up on the control panel display.
NOTE: When in SLEEP mode, the fan will run on low to keep fan noise at a minimum. The temperature
setting will gradually increase to 2°F above the original set temperature each of first 2 hours. The unit will
keep operating the same temperature until the sleep mode is turned off.
Fan Mode
1) Plug the Power Cord into an electrical outlet.
2) Turn on the unit by pressing the POWER button on the control panel.
3) Press the MODE button until the fan mode indicator lights up on the control panel display.
4) Select the fan speed by pressing the FAN SPEED button.
NOTE: It is not necessary for the exhaust hose and window kit to be installed to operate the unit in fan
mode.
Bucket Full Indicator
When the Internal Water Tank is full, the Bucket Full light will illuminate and the unit will automatically
shut down. The air conditioner will resume normal operation once Internal Water Tank is emptied.
Internal Water Tank
When the room temperature is low and the indoor humidity is high, the air conditioner may not be able to
evaporate some of the moisture fast enough. When this happens, the water will accumulate in an internal
water tank inside the unit. The internal water tank holds approximately 1.5 liters of water. When this tanks
becomes full, the unit will automatically shutdown and illuminate the Bucket Full indicator.
Advertisement
Table of Contents
