Target List - Vesper AIS WatchMate 850 Manual

Target List

The target list contains all non-filtered targets. You can scroll through the list to select a
target to view in detail. By default, the target list is continuously ordered by priority. The
priority of a target is based on its CPA, TCPA, range, and speed. Higher priority targets are
shown at the top of the list. In setup mode you can disable this feature if you wish and
targets will be displayed in the order they were first received.
Each target shown in the target list indicates the CPA as well as the bearing and range from
your vessel to the target. This facilitates visual identification. In setup mode you can change
whether bearings are shown as true, magnetic, or relative to your vessel's heading.
If the target and your vessel are not converging, such as when they are moving apart, the
target's CPA is blank.
If you wish, in setup mode you can configure the target list to display each target's speed
over ground (SOG) rather than CPA.
When this screen is displayed, you can use the following buttons:
▲
Scroll your selection up. This button is only active if it is possible to scroll up.
▼
Scroll your selection down. This button is only active if it is possible to scroll down.
Select Display detailed information about the selected target.
Home Return to the situation display.
- 30 -