Table of Contents
Advertisement
INSTALLATIoN
Appliance description
- The electrical resistivity of the water must not fall below that
stated on the type plate. In a linked water network, take into
consideration the lowest electrical resistivity of the water.
Your water supply utility will advise you of the electrical re-
sistivity or conductivity of the water in your area.
8.
Appliance description
8.1
Standard delivery
The following are delivered with the appliance:
- Wall mounting bracket
- Installation template
- 2 twin nipples
- 3-way ball shut-off valve for cold water
- Tee for domestic hot water
- Flat gaskets
- Strainer
- Plastic profile washer
- Plastic connection pieces / installation aid
- Cover and back panel guides
- Jumper for internal anti-scalding protection
- Jumper for output changeover (only with DHE 18/21/24)
www.stiebel-eltron.com
8.2
Accessories
Wireless remote control
- FFB 4 Set EU
Fittings
- MEKD mono lever kitchen pressure tap
- MEBD mono lever bath pressure tap
Water plugs G ½ A
If you use taps other than the recommended pressure taps on
finished walls, please use the plugs.
Installation set for finished walls
- Solder fitting – copper pipe for soldered connection Ø 12 mm
- Press fitting – copper pipe
- Press fitting – plastic pipe (suitable for Viega: Sanfix-Plus or
Sanfix-Fosta)
Universal mounting frame
- Mounting frame with electrical connections
Pipe assembly for undersink appliances
You will need the undersink installation set if you make the water
connections (G ⅜ A) at the top of the appliance.
DHE |
73
Advertisement
Table of Contents
