Fault
All LEDs lit up or flashing.
Mechanical damage
Fault
Appliance door cannot be
closed.
Lid on the detergent dis-
penser cannot be closed.
Noise
Fault
Filling valves making knock-
ing noises.
Knocking or rattling noise.
Cause
Electronics have detected a
fault.
Cause
Door lock has been activ-
ated.
Door cannot be closed due
to installation method.
Detergent dispenser or lid
are blocked by sticky deter-
gent residue.
Cause
Caused by the domestic in-
stallation. No appliance fault
present. Does not affect
functioning of the appliance.
Spray arm is striking table-
ware.
Troubleshooting en
Troubleshooting
Press the main switch button for ap-
1.
prox. 4 seconds.
→ "Controls", Page 14
The appliance is reset and restar-
ted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or
‒
switch off the fuse in the fuse
box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse
‒
box or insert the mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service",
Page 51
Troubleshooting
Close the appliance door with
▶
greater force.
Check whether the appliance has
▶
been installed properly.
When closed, the appliance door,
its decor or attached parts should
not knock against adjacent cabin-
ets or the worktop.
Remove detergent residue.
▶
Troubleshooting
Can only be remedied in the do-
▶
mestic installation.
Arrange tableware so that the spray
▶
arms do not strike tableware.
47
Need help?
Do you have a question about the SMV2ITX00X and is the answer not in the manual?
Questions and answers