Sony DAV-DZ361W Operating Instructions Manual page 77

7
Press X/x to select [AUDIO SETUP],
then press .
The options for [AUDIO SETUP] appear.
8
Press X/x to select [S-AIR SETUP t],
then press .
9
Press X/x to select [PAIRING], then
press .
The confirmation display appears.
10
Press C/c to select [YES], then press
.
The unit starts pairing.
To not perform pairing, select [NO].
11
Start pairing of the S-AIR sub unit.
x For the surround amplifier
Press POWER on the surround amplifier to
turn on the surround amplifier and press
PAIRING on the rear panel of the surround
amplifier.
The PAIRING indicator of the surround
amplifier flashes red when pairing starts.
When sound transmission is established,
the PAIRING indicator of the surround
amplifier turns red and the confirmation
display appears.
Tip
• To press PAIRING on the rear panel of the
surround amplifier, a slim instrument, such as a
paper clip, can be used.
x For the S-AIR receiver
Refer to the operating instructions of the
S-AIR receiver.
When sound transmission is established,
the confirmation display appears.
Note
• Perform the pairing within several minutes after
Step 10. If you do not, the pairing is canceled
automatically and the confirmation display
appears. To perform pairing, select [YES]. To
return to the previous display, select [NO].
12
Press C/c to select the next operation.
x To finish pairing
Select [NO], then press
x To perform pairing of another S-AIR
sub unit
Select [YES], then press
Note
• If you perform the pairing operation between the unit
and another S-AIR sub unit (page 76), sound
transmission established by ID is canceled.
• When you perform pairing, [(PAIRING)] appears
beside ID on the display for selecting ID.
To cancel pairing
Perform the ID setting of the unit according to
the procedure of "To set the ID of the unit." If
you select a new ID (you can select the same ID
as before), pairing is canceled.
For the surround amplifier
For the S-AIR receiver
If you use multiple wireless systems which
sharing the 2.4 GHz band, such as wireless LAN
or Bluetooth, the transmission of S-AIR
products or other wireless systems may be
unstable. In this case, the transmission may be
improved by changing the following "RF
CHANGE" setting.
1
2
3
4
5
.
6
.
If sound transmission is
unstable
Press SYSTEM MENU.
Press X/x repeatedly until "RF
CHANGE" appears in the front panel
display, then press
Press X/x to select the desired setting.
• "AUTO": Normally select this. The
system change "RF CHANGE" to "ON"
or "OFF" automatically.
• "ON": The system transmits sound by
searching the better channel for
transmitting.
• "OFF": The system transmits sound by
fixing the channel for transmitting.
Press .
The setting is made.
Press SYSTEM MENU.
The system menu turns off.
When you set "RF CHANGE" to "OFF,"
select the ID so that sound
transmission is most stabilized
(page 73).
or c.
77
GB