Download Print this page
Westfalia 82 86 72 Assembly Instruction Manual
Westfalia 82 86 72 Assembly Instruction Manual

Westfalia 82 86 72 Assembly Instruction Manual

Wheelbarrow and snow collector 70 l

Advertisement

Available languages

Available languages

Quick Links

Montageanleitung
Kippkuli und Schneeschieber
70 l
Artikel Nr. 82 86 72
Assembly Instruction
Wheelbarrow and Snow Collector
70 l
Article No. 82 86 72

Advertisement

loading

Summary of Contents for Westfalia 82 86 72

  • Page 1 Montageanleitung Kippkuli und Schneeschieber 70 l Artikel Nr. 82 86 72 Assembly Instruction Wheelbarrow and Snow Collector 70 l Article No. 82 86 72...
  • Page 3 Seitenteil rechts Right Side Panel Hinteres Bodenblech Rear Panel Griffstange Handle Schubstange Push Bar Abstellfüße Stands Achse Axle Wheel Seitenteil links Left Side Panel Verstärkungsstrebe Brace Vorderes Bodenblech Floor Panel Winkelblech Angle Bracket Knaufschraube 55 mm Knob Screw 55 mm M5 Mutter + Inbusschraube M5 Nut + Allen Head Screw Splint...
  • Page 4 Montage Bitte überprüfen Sie vor Beginn des Zusammenbaus die Lieferung auf Vollständigkeit. Sie benötigen Inbusschlüssel der Größe 3 und 4 mm und Maulschlüssel der Größe 8 und 10. Beim gesamten Aufbau werden die Schrauben von innen eingesetzt und die Muttern von außen aufgeschraubt. Ziehen Sie erst die Schrauben locker an.
  • Page 5 Montage der Achse und der Abstellfüße Montieren Sie die Abstellfüße (5). Hinweis: Die Bohrungen für die Knauf- schrauben müssen sich auf der gegen- überliegenden Seite der Achse befinden (siehe Pfeile). Setzen Sie erst die Winkelbleche durch die Achse, bevor Sie diese an der Wanne be- festigen.
  • Page 6 Benutzung / Using Aufnehmen Laub, Sand, Gartenabfällen (Rasenschnitt/Unkraut), schieben Sie die Griffstange (3) in die aufrechte Position. Fixieren Sie die Knauf- schrauben (A). For collecting leaves, sand, garden waste (lawn cuttings or weeds), push the handle (3) in the upright position and tighten the handle with the knob screws (A).
  • Page 7 Mounting Before staring work on the wheelbarrow, make sure the shipment is complete. To assemble the wheelbarrow, you require 3 and 4 mm Allen spanners and 8 and 10 mm fork spanners. All screws are inserted with the screw head on the inside and the nuts on the outside of the wheelbarrow.
  • Page 8 (C). Bend both ends of the splint pins outside. If necessary pump up the wheels. Make sure not to pump more than 2 bars. After the assembly is complete, tighten all screws and check the pressure of the tyres. Gestaltung urheberrechtlich geschützt © Westfalia 11/14...