Filling The Salt Reservoir; Refilling The Salt - Miele PFD 104 SCVi Operating Instructions Manual

Filling the salt reservoir

Before filling the salt reservoir for the
first time, you must fill it with approx.
2 l of water to enable the salt to dis-
solve.
Once the dishwasher has been used
once, there is always sufficient water
in the salt reservoir.
 Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.
 Fill the salt reservoir with approx. 2 l
of water (first use only).
 Place the funnel provided over the
salt reservoir and carefully fill with re-
activation salt until the reservoir is
full. The salt reservoir holds up to
2 kg of salt, depending on the type of
salt used.
 Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
Initial commissioning

Refilling the salt

 When the refill reminder 
appears in the display, wait until the
end of the program and then refill the
salt reservoir.
 Confirm with OK.
The salt refill indicator will go out.

Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the wash items.
Each time you remove the salt reser-
voir cap, you must run the  Cold
pre-rinse program without any wash
items in the dishwasher. This will dis-
solve and remove any traces of salt
from the wash cabinet.
After the salt reservoir has been filled,
the refill indicator may still appear in the
display if the salt concentration has not
yet reached the correct level. In this
case, still confirm the message with OK.
Refill salt
29