Table of Contents
Advertisement
CYLINDER GLAND SERVICE DIAGRAM
All gland seals shown with a sec on removed
to facilitate correct installa on.
ROD WIPER
EZ SQUEEZE SEAL
GLAND
BACK UP
O-RING
SECTION VIEW
ASSEMBLED GLAND
CYLINDER PISTON SERVICE DIAGRAM
To Remove Seals
Carefully cut across each seal with a sharp knife. Be sure
not to scratch sealing surfaces of aluminum piston. If a
sharp knife is not available. An electric soldering gun or
hot iron may be used to melt throughout seals
O-RING
EZ SQUEEZE SEAL
PISTON
EZ SQUEEZE SEAL
Note: To install rod wiper and EZ-squeeze seal,
fold similar to shape shown below, slip into
gland bore and locate each in its respec ve
groove. Tools are used to fold seals, take care
not to damage sealing surfaces.
GLAND
ROD WIPER
EZ SQUEEZE SEAL
BACK UP
O-RING
Important! Be sure all gland and piston seals have been installed
correctly before cylinder is assembled!
To Install Seals:
1. Thoroughly clean piston sealing surface of all
2. Heat new seals in hydraulic oil to 160° F.
3. Remove seals from oil, wipe dry and install in
le .
in piston grooves before allowed to cool.
4. Replace piston on cylinder sha and
assemble
cooled to room
SECTION VIEW
ASSEMBLED PISTON
Page 18
foreign ma er.
Never use a direct flame or heated water on
hydraulic seals.
piston grooves as shown in illustra on at
Be sure seals have completely seated
cylinder when seals have
temperature.
O-RING
EZ SQUEEZE SEAL
PISTON
EZ SQUEEZE SEAL
Advertisement
Table of Contents
