General Characteristics - ABB Thomas & Betts BPLT62BSCR Operating Instructions Manual

1.0
WARNING
1. BEFORE USING THE TOOL, CAREFULLY READ
INSTRUCTIONS IN THIS MANUAL.
2. WHEN OPERATING THE TOOL, KEEP HANDS AND OTHER
BODY PARTS AWAY FROM THE DANGER ZONE.
3. DO NOT USE IN WATER OR IN THE RAIN.
4. ALWAYS ENSURE CORRECT LATCHING AND
SECURENESS OF THE TOOL HEAD.
5. DO NOT SHORT THE BATTERIES.
6. ALWAYS RECYCLE THE BATTERIES.
7. DO NOT DISCARD BATTERIES INTO DOMESTIC REFUSE
OR WASTE DISPOSAL.
1 2 3
1.1
BATTERY OPERATED
HYDRAULIC CRIMPING TOOL
This "BPLT62BSCR" hydraulic tool is powered by 14 4 V
DC Ni-MH battery The tool is well balanced for optimum
control, quiet operation, very little vibration and lightweight
construction enabling the operator to hold the tool in
one hand while positioning the connector with the other
hand The tool has a two speed operation which provides
automatic shifting from a rapid ram advance mode to
a slow powerful crimping mode The residual battery
capacity level is automatically displayed after every cycle
BPLT62BSCR Includes the following:
• Battery • Wrist Strap
• Spare Battery • Battery Charger
BPLT62500BSCR Includes the following:
• Battery • Wrist Strap
• Spare Battery • Battery Charger
• Carrying Case
1.2
APPLICATION RANGE
Suitable for installing electric compression connectors for
conductors from 8 AWG up to 500 MCM CU, 350 MCM AL.
Crimping Force Nominal
Rated Operating Pressure
Dimensions:
Length
Width
Height
Weight (with battery)
Motor
Battery - direct current
Oil Recommended..................AGIP ARNICA 32 or
SHELL TELLUS TX32 or equivalent
Safety the tool is provided with a
maximum pressure relief safety valve
TA03943 D Page 2 of 8

GENERAL CHARACTERISTICS

Ni-MH
4 4 5 6
• Tool Strap
• Carrying Case
• Tool Strap
• Die Set
6 Tons
8600 psi
8 8 lbs
14 4V DC
14 4 V - 3 0 Ah Ni-MH
1.3
(Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
The weighted continuous acoustic pressure level
equivalent
A at the work place L
The maximum value of the weighted acoustic
displacement pressure
C at the work place L
The acoustic power level emitted by the machine
L is equal to
WA
1.4
RISK DUE TO VIBRATION
7
(Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Test carried out in compliance with the indications
contained in UNI ENV 25349 and UNI EN 28662
part 1st Standards, and under operating conditions
much more severe than those normally found,
certify that the weighted root mean square in
frequency of the acceleration the upper limbs are
exposed to for each biodynamic reference axis
does not exceed 2.5 m/sec
1.5
H
10
201
11 7"
16
3 7"
Fig. 1
11 9"
10
Operating Button
14
Wrisp Strap
15
Battery Capacity Indicator
16 Battery
ACOUSTIC NOISE
is equal to
PA
is <130 dB (C)
pCPeak
.
2
OVERALL VIEW
R
T
15
R
14
201
Pressure Release Lever
H
Head
R
Ring for Shoulder Strap
T Shoulder Strap
75 dB (A)
85,3 dB (A)