Table of Contents
Advertisement
1.0
1.1
SAFETY RULES
1. BE FAMILIAR WITH YOUR TOOL.
Read the instruction manual. Become aware of its proper
usage as well as the potential hazards.
2. KEEP WORK AREA CLEAN AND WELL LIGHTED.
Poor lighting and cluttered areas invite accidents.
3. USE SAFETY GLASSES.
4. MAINTAIN TOOL WITH CARE.
Keep tool in good condition at all times. Keep it clean for
best and safest performance.
5. DON'T OVER-REACH.
Keep proper footing and balance at all times.
6. NEVER ATTEMPT TO MAKE A COMPRESSION ON A
"HOT" LINE.
Never assume the power is OFF! Determine beforehand if
any electrical hazards could exist when making a
connection to a line or wire.
7. KEEP FINGERS AND OTHER BODY PARTS AWAY
FROM COMPRESSION DIES & MOVING PARTS.
Tools are NOT insulated for use on or near
energized conductors. Use of these tools
near energized conductors may lead to
electrical shock, causing severe injury or
death. DO NOT use these tools near
energized conductors without adequately
insulating operator and surroundings.
Pinch point hazard. Compression Dies at high
force can cause severe personal injury. Keep
all body parts away from moving parts of the
tool during operation.
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability of this product for the user's
intended application. Thomas & Betts warrants that this product will be free from defects in materials and workmanship for the period stated on the enclosed warranty card.
Upon prompt notification of any warranted defect, Thomas & Betts will, at its option, repair or replace the defective product. Misuse, misapplication or modification of Thomas
& Betts products immediately voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL OTHER WARRANTIES
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH
ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT,
AND UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
IMPORTANT: Read and understand all of the
instructions and safety information in this manual
before operating or servicing this tool.
GENERAL INFORMATION
WARNING
WARNING
1.2
• Fully automatic, self-contained power tool.
• Removable battery cartridge - simply change the
cartridge for continuous use.
• One handed operation.
• Accepts Burndy "W" Dies.
• Fully enclosed weather resistent housing.
• LED work lights.
1.3
SPECIFICATIONS
HYDRAULIC COMPRESSION TOOL:
Drive Unit:
14.4V DC Motor
Dimensions:
18"L x 3.5" W x 4.5"H
Weight:
8.75 lbs. with battery
Capacities:
#8-600 kcmil CU or
#8-400 kcmil Aluminum
Jaw Opening:
1.8"
Output:
6 Tons
BATTERY:
144-BAT-LI
Battery Type:
Sealed Lithium Ion
Voltage:
14.4V DC
Dimensions:
4.2"L x 3.3W x 2.6H
Capacities:
3.0Ah
Weight:
1.2 lbs.
Charging time: 25 min. 80% Capacity
45 min. 100% Capacity
CHARGER:
144-CHR-LI
Input Voltage: 120 - 240 V AC Single Phase
Dimensions:
9"L x 5.7W x 3.2H
Weight:
3.5 lbs.
FEATURES
TBM62CR-LI
TA04713 A Page 2 of 8
Advertisement
Table of Contents
