Instructions For Use; Warnings - ABB Thomas & Betts BPLT62BSCR Operating Instructions Manual

2.0
2.1
The tool can be easily carried using either the handle or
shoulder strap (T) attached to the rings (R), see Fig 1 on
page 2
With the tool at rest, proceed as follows:
• Select the appropriate die set for the connector
(Ref: Check Thomas & Betts instruction sheet for the
connector and make sure color code of die matches
color code of connector )
• Open the latch (41) and release the upper die holder (42)
• Insert one die into the upper die holder (42) and one
die into the lower die support (49)
• Close the latch (41)
• Insert the conductor in connector.
• Position the connector between the dies and ensure
the correct location of the crimp (See connectors
instruction sheet for number of crimps )
Ensure that the latch and upper die holder are fully
secured, otherwise damage may occur during tool
operation.
2.2
DIE ADVANCEMENT
• Press the operating button (10) to activate the
motor-pump and advance the lower die To halt the
advancement, release the operating button (10) and the
motor will stop
Make sure the dies are exactly positioned on desired
crimp point, otherwise re-open dies following instructions
as per Step 2.5 and position the connector again.
10
201
Fig. 3
2.3
COMPRESSION
• By keeping operating button (10) pressed, the motor
continues to operate: the ram will gradually move
forward until the two dies touch
• It is recommended to continue pumping until the
maximum pressure relief valve is activated and a
"click" is heard
• The motor will continue to operate after the maximum
pressure relief valve has activated No further crimping
force is applied, the oil is bypassed and returned to
reservoir

INSTRUCTIONS FOR USE

PREPARATION
(Refer to Fig 3)
(Refer to Figs 1, 2 & 3)
42
83
Fig. 2
WARNING
When operating the tool, keep hands and other body parts
away from the danger zone.
2.4
HEAD ROTATION
• For ease of operation, the tool head can be rotated
through 180º, allowing the operator to work in the most
comfortable position
WARNING
Do not attempt to rotate the head when the hydraulic
circuit is pressurized.
2.5
RELEASE OF DIES
• By pressing the pressure release lever (201) located
below operating button (10), the ram will retract and
open the dies
DANGER
DO NOT USE THIS TOOL ON OR
NEAR ENERGIZED CONDUCTORS
WITHOUT PROPER PERSONAL
PROTECTIVE EQUIPMENT.
FAILURE TO OBSERVE THIS
WARNING COULD RESULT IN SEVERE
INJURY OR DEATH.
41
62
49
TA03943 D Page 3 of 8