Maintenance - ABB Thomas & Betts BPLT62BSCR Operating Instructions Manual

3.0
The tool is supplied with the batteries completely discharged; before use, fully charge the batteries using the charger supplied.
3.1
BATTERY STATUS
• After releasing the operating button, the residual
battery capacity is automatically displayed for 5
seconds on the indicator (15)
The number of LEDs illuminated indicates
the residual capacity:
10 LEDs illuminated: Fully Charged
5 LEDs illuminated: 50% capacity
1 LED illuminated: Minimum charge
When replacing the battery, press the two points
marked with the word "PUSH" at the same time, remove
the flat battery from its housing and insert the new one
15
Fig. 4
4.0
The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with the following points,
should help to maintain the optimum performance of the tool:
4.1
Dust, sand and dirt are a danger for any hydraulic device Every day, after use,
the tool must be wiped with a clean cloth taking care to remove any residue,
especially close to pivots and moveable parts Protect the tool from rain and
moisture. Water will damage the tool and battery.
4.2
When not in use, the tool should be stored and
transported in the plastic case, to prevent damage This
case is suitable for storing the tool, the accessories
and up to 21 die sets and pre-prepared compression
connectors
Plastic Case: size 24 1x16 2x5 1 inches, (543x412x130
mm) weighs 5 lbs (2,3 kg)
TA03943 D Page 4 of 8
BATTERY USE
(Refer to Fig 4)
%

MAINTENANCE

THOROUGH CLEANING
STORAGE
3.2
USING THE BATTERY CHARGER
Carefully follow the instructions in the battery
charger manual
3.3
USING BATTERIES
In order to use the batteries correctly, please follow
these rules:
• Use the battery until the automatic residual energy
display still has 1-2 LEDs showing: this means the
battery is almost completely discharged and no loss
in the life of the battery has been produced
• Be particularly careful when charging a new battery
the first 2-3 times in order to maximize the available
energy level
• Allow the battery to cool down to ambient
temperature prior to recharging
• Rest the battery charger for at least 15 minutes
between charges
(Refer to Fig 5)
Fig. 5