Adjustments - Hornbach PE-500TBM Manual

INSTALLATION
1 Mount the base plate 18
stable surface using 4 screws (not in-
cluded).
Install the column 4
using the three M8x20 screws, spring
washers and washers.
3 Install the motor unit to the column
and tighten its four grub screws.
Install the three handles 8
unit.
SPINDLE SPEED
1 Loosen both motor adjustment
and open the gear box
ing the gear box screw 15.
Caution! Make sure the tool is
switched off and unplugged.
3 Push back the motor 16, tighten the
motor adjustment knobs
the gear box lid 1 by tightening the gear
box screw 15.
FIT APPLICATION TOOL
1 Open the guard 9, insert the applica-
tion tool into the chuck 13
tighten with the chuck key.
Caution! Make sure the tool is
switched off and unplugged.
to a level and
to the base plate 18
4
to the motor
knobs 3
lid 1 by loosen-
3 and close
and securely
2 Slide the table 10
and lock it with the table handle 17.
Install the machine vice
ble 10 using the two M10x35 screws,
washers and nuts.
4 Install the chuck 13
pushing it onto the drill shaft.
Install the guard 9 to the motor unit.
2 Pull the motor 16 towards the
and set the desired spindle speed with
the two belts:
Gear min
A4 500
B4 680
A3 770
C4 830
A2 980
B3 1100
C2 1600
B1 2000
C1 2500
2 Close the guard 9. Use the two screws
on the guard to adjust it to the height of
the workpiece.
onto the column 4
6 to the ta-
to the motor unit by
chuck 13
-1
EN 87