Product Overview; Using The Tool; Intended Use - Hornbach PE-500TBM Manual

Product overview

1 Gear box lid
2 On/off switch
3
Motor adjustment knob
4
Column
5 Supply cord
6 Machine vice
7 Emergency off
8 Handle
9 Guard
10 Table
11 Mounting hole
12 Depth gauge
13
Chuck
14
Machine vice handle
15 Gear box screw
16 Motor
17 Table handle
18 Base plate

Intended use

In conjunction with the respective application
tools, the machine is intended for drilling in
wood, metal, and plastic. The tool is not in-
tended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
SECURE WORKPIECE
1 Loosen the table
table 10 to the desired height and/or
orientation.
86 EN
handle 17 and set the

Using the tool

1. Set the desired spindle speed.
2. Fit application tool into the
securely tighten it with the chuck key.
3. Secure the workpiece in the machine
vice 6.
4. Adjust the table 10 according to the work-
piece.
5. Adjust the guard 9
workpiece.
6. Set the drill depth on the depth
if required.
7. Switch the tool on using the on/off
switch 2.
8. Use the handle 8
pressure and feed the application tool into
the workpiece.
9. Switch the tool off using the on/off
switch 2.
10. Remove the workpiece after the rotating
parts have come to a complete stop.
11. Clean the drilling area from chips using
a brush or hook and remove the applica-
tion tool from the chuck 13
chuck key.
Caution! In case of emergency
press the emergency off button to
stop all operations immediately.
2 Secure the workpiece in the machine
vice 6 and tighten the table handle 17.
Adjust the guard
and tighten the guard screws.
chuck 13 and
to the height of the
gauge 12
to apply downward
by use of the
9 to the workpiece