Sony KDS-55A2000 Operating Instructions Manual page 8

2
Press 1 on the TV (front).
When you switch on the TV for the first time, the
Language menu appears on the screen.
When the TV is in standby mode (the
standby) indicator on the TV (front) is red), press
TV "/1 on the remote to switch on the TV.
3
F f G g
Press / / /
displayed on the menu screens, then press
.
4
F f
Press / to select the country/region in
which you will operate the TV, then press
.
If the country/region in which you want to use the
TV does not appear in the list, select "-" instead of
a country/region.
The message confirming the TV start auto-tuning
appears on the screen, then go to "5: Auto-tuning
the TV".
8
GB
1
(on/
to select the language
5: Auto-tuning the TV
The TV will search for and store all available TV
channels.
1
Before you start auto-tuning the TV, insert
a pre-recorded tape into the VCR
connected to the TV (page 7) and start play
back.
The video channel will be located and stored on
the TV during auto-tuning.
If no VCR is connected to the TV, skip this step.
2
G g
Press / to select "OK", then press
The TV starts searching for all available digital
channels, followed by all available analogue
channels. This may take some time, please be
patient and do not press any buttons on the TV or
remote.
If a message appears for you to confirm the aerial
connection
No digital or analogue channels were found.
Check the aerial connection and press G
select "Yes", then press
again.
2
2
4
.
/ g to
to start auto-tuning