Sony KDS-55A2000 Operating Instructions Manual page 49

6
Pull out the lamp.
Hold the indented grooves of the lamp as
shown, and pull the lamp straight out.
If the lamp is hard to remove, pull the right
side of the lamp for additional traction
(KDS-55A2000).
KDS-55A2000
Hold this part of the lamp
KDS-70R2000
Hold this part of the lamp
Notes
• Do not touch the inside of the lamp compartment.
• The lamp is very hot immediately after use. Never
touch the glass portion of the lamp or the surrounding
parts.
• After the used lamp has cooled, place it into the empty
box of the replacement lamp. Never put the used lamp
into a plastic bag.
7
Put the new lamp into its place.
Make sure the lamp is securely mounted
into the compartment. Failure to do so may
cause a fire or the screen to go dark.
KDS-55A2000
KDS-70R2000
Notes
• The lamp compartment is tilted.
• If the lamp is not securely reattached, the self-
diagnostic function may be triggered and
red three times (page 15).
KDS-55A2000
8
Reattach the lamp door.
For KDS-55A2000, replace the door by
inserting the two tabs in the slot from the
left side. Slide the lever to the right and
then turn the screw clockwise to secure the
door.
For KDS-70R2000, turn the knob to the
right while pushing the door in, until the
marks on the lid and the case line up. Then
turn the screw clockwise to secure the
door.
KDS-55A2000
KDS-70R2000
1
flashes in
KDS-70R2000
Continued
49
GB