Getting Started - Kogan KAKIDINCMRA User Manual

GETTING STARTED

Loading the printer paper
Use the pull tab to open the paper compartment. Insert the roll of thermal printer paper
(57mm x 25mm) into the paper compartment, ensuring the roll is facing the same direction
as shown in the image below (rolling under then back from above).
Fit the roll so some of the paper is feeding out through the slot, then close the paper
compartment and tear off the excess paper exposed on the outside.
Correct direction for thermal paper roll
Installing microSD card
The SD card slot is below the safety cover at the top of the camera. This device will not work
with a card above 32GB capacity. To eject the card, push inward.
Charging the camera
Insert a USB-C cable into the charging port at the top of the camera (below safety cover),
and connect the other end into a USB power adapter (5V/2A). Once power is connected, the
camera will begin charging.
The indicator light is Red while charging is in progress, and will turn off when fully charged.
The camera will give a low battery prompt when further charging is required.
Powering on
Once fully charged, press the Power button once to turn the camera on. By default, it
will start in Photo mode, with the rear lens.