Dell OptiPlex 7090 Small Form Factor Service Manual page 47

Table of Contents

Advertisement

About this task
The following image indicates the location of the processor and provides a visual representation of the installation procedure.
Steps
1. Ensure that the release lever on the processor socket is fully extended in the open position.
2. Align the notches on the processor with the tabs on the processor socket and place the processor in the processor socket
on the system board.
NOTE:
Ensure that the processor-cover notch is positioned underneath the alignment post.
NOTE:
The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor
socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of
the processor are higher than the others, the processor is not seated properly.
3. When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor
cover.
Next steps
1. Install the
fan and heat-sink
2. Install the
2.5/3.5-inch hard-drive
3. Install the
side
cover.
assembly.
caddy.
Removing and installing components
47

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OptiPlex 7090 Small Form Factor and is the answer not in the manual?

Table of Contents

Save PDF