Powering on
Notes:
1. Your new IBM 4836 ships with a control cover. If you want the buttons covered,
2. A small hole ( E in Figure 11) under the control cover allows you access to the
3. A screwdriver is required to pry off the cover.
Figure 11. IBM 4836 controls and installing the control cover
1. Plug the power adapter into the 4836.
2. Plug the power adapter into an electrical outlet.
3. Power on the IBM 4836 using the power switch (see A in Figure 11). The
4. To adjust the brightness, select the plus + ( B ) or minus – ( C ) keys.
Installing the control button cover
See Figure 11. To install the control button cover ( D ), follow these steps:
1. Match the alignment pins on the button cover with the hole between the buttons.
2. Snap into place.
16
Anyplace Kiosk 4836
install this part after you power on and adjust the image.
reset switch. Use a paperclip or other small tool to activate the switch.
4836 power light-emitting diode (LED) will initially appear green.