LogTag Recorders USRIC-4 Software Download And Quick Start Manual

Multi-use

Hide thumbs Also See for USRIC-4:

SOFTWARE DOWNLOAD AND QUICK START GUIDE

FOR MULTI-USE LOGTAG RECORDERS

(USRIC-4- USB recorder- SINGLE use)

LogTag recorders are received in a "hibernation" state to conserve battery

life.

Prior to use they must be configured to suit your requirements.

Step 1:

Download LogTag Analyser as follows:

http://logtagrecorders.net/download/software/analyzer/release/ltanalyzer_28r2.exe

Click on the software download. Save / Run

Download – LogTag Analyser 2.8 r 2

LogTag Analyser will automatically download and create a desktop

shortcut.

YOU ARE NOW ENABLED TO CONFIGURE AND READ LOGTAGS

Step 2:

Open the Logtag analyser programme on your computer.

Plug in your USRIC-4 into a USB port on your computer (Initially the

driver software will self-install). The software will recognise the

logtag as having no data recorded.

Tel: 021 852 7686

Fax: 086 664 7173

Email: info@logtagdata.com

43 Bright street, Somerset West, 7129

Table of Contents

Need help?

Do you have a question about the USRIC-4 and is the answer not in the manual?

Page 1 YOU ARE NOW ENABLED TO CONFIGURE AND READ LOGTAGS Step 2: Open the Logtag analyser programme on your computer. Plug in your USRIC-4 into a USB port on your computer (Initially the driver software will self-install). The software will recognise the logtag as having no data recorded.
Page 2 Step 3: (Configure/ Set up) A blank screen will re-appear with a menu bar along the top. Click on LogTag on the top menu and select „Configure‟ in the drop down menu. The program will automatically „Locate LogTag‟ ( Top left screen) Click Next for the Arrow to move down to configure Logtag.
Page 3 Example: Configuration Screen. All Configuration options will be loaded onto the Logtag device for use. Step 5: Your LogTag is NOW ready for use. Tel: 021 852 7686 Fax: 086 664 7173 Email: info@logtagdata.com 43 Bright street, Somerset West, 7129...
Page 4 TO START – Push and hold down the „start/mark‟ until the red and green/ starting display indicators flash rapidly and then release. Your recorder is now ACTIVE and will begin recording. TO STOP - Open Logtag Analyser on the computer and plug in the USB Logtag.