Table of Contents
Advertisement
en Troubleshooting
Fault
Water is not flowing
in. Detergent is not
being dispensed.
The spin cycle runs
several times.
The programme dura-
tion changes during
the wash cycle.
No water is visible in
the drum.
Drum jerks after the
programme starts.
Residual water is
present in the com-
partment
.
42
Cause and troubleshooting
You have not pressed
Press
.
▶
The filters in the water inflow are blocked.
Clean the filters in the water inflow.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
Water is below the visible area.
Not a fault – no action required.
▶
Do not add any extra water to the appliance while it
▶
is operating.
This is caused by an internal motor test.
Not a fault – no action required.
▶
Insert in compartment
→ "Cleaning the detergent drawer", Page 34
▶
.
is blocked.
Advertisement
Table of Contents
