Table of Contents
Advertisement
How to switch on remotely, using only Web Communicator?
1.
Ensure that the XDM projector is installed onto a stable platform.
2.
Ensure the projector is correctly connected to the mains power.
3.
Ensure that the correct lens is installed for your application.
4.
Browse to the IP address of the projector, using the http protocol.
With the projector in ECO mode, you will be redirected to the ECO mode page.
Image 5–5 Example of the Eco Mode page in Web Communicator
5.
On the Eco mode page, press Wake up.
The projector will start up. Once it has fully started up, you will be redirected to the login page of Web
Communicator.
6.
Once the login page becomes available, log in to the projector.
Once logged in, you will be redirected to the Light, dowser, lens menu.
7.
In this menu, press the Light button to activate the light source. Use a press of >1 second.
The Light source will start warming up.
8.
Press the Dowser button to open the dowser.
How to switch on remotely, using only GPI3?
1.
Ensure that the XDM projector is installed onto a stable platform.
2.
Ensure the projector is correctly connected to the mains power.
3.
Ensure that the correct lens is installed for your application.
4.
Ensure that the GPI port is connected to a supported automation controller (e.g. a JNIOR device).
5.
Send a signal to GPI3 for more than 0.5 seconds (but less than six seconds).
Tip: GPI3 works in a similar fashion to the power button. So sending a signal for six seconds or
more will force the projector OFF instead.
CAUTION: See the User Guide of the projector to operate and control the projector.
Starting the projector for the first time
R5914477 /00
XDM
71
Advertisement
Table of Contents
