Remote Control Instructions - KEKAI Tornado Instruction Manual

OPERATING
Product Key Function:
1. Turn on the power button, the product is in standby mode display (- -);
2. Press heating level button: select the heating level (L1-L2 standby - off)
3. Press timer button:To set the timer from 0H-24H, which is the number of hours it will run. 0H will display and then
adjust to the number of hours you would like to set.

Remote Control Instructions

Inserting Batteries(not included)
Insert 2 AAA/ Alkaline type batteries into your remote control
1. Flip the backside of your remote control and pull out battery cover. Insert the batteries in accordance with the instruc-
tions and polarity the batteries.
2. Change the batteries in the same way depicted above.
NOTICE:
1. Replace the old batteries with the same type batteries. Otherwise, your heater may not function well.
2. Pull out the batteries in case of long terms of disuse to prevent leakage which may impair your remote control.
3. Do not allow water or liquid to get into the remote control.
CAUTION:
When the appliance is not operated for a long period of time, cleaning or maintenance is conducted or when the location
of the heater is changed, the heater should be turned to OFF and unplugged from the electrical connection.
Periodic inspection and removal of dirt and contaminants will ensure that equipment can be operated safely.
1. POWER BUTTON: Turn the heater off.
2. UP BUTTON: Increase timer or power level.
3. DOWN BUTTON: Decrease timer or power level.
4. LEVEL BUTTON: Use to adjust the heat levels(L1-L2). Press the Level button
then use the up and down buttons(buttons 2 and 3) to increase or decrease the
heating level.
5. TIMER BUTTON: To set the timer from 0H-24H, which is the number of hours it
will run. 0H will display and then adjust to the number of hours you would like to set,
using the up and down buttons(2 and 3).
Noted: All heaters and their remote controls have the same frequency, so it is possi-
ble to control several heaters with just one remote.