Gigabyte X570 Aorus Ultra User Manual page 19

10) LED_C1/LED_C2 (RGB LED Strip Headers)
DEBUG DEBUG
PORT PORT
The headers can be used to connect a standard 5050 RGB LED strip (12V/G/R/B), with maximum power
rating of 2A (12V) and maximum length of 2m.
1
LED_C1 LED_C2
1
12V
For how to turn on/off the lights of the LED strip please visit the "Unique Features" webpage of
GIGABYTE's website.
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
11) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA connectors support
RAID 0, RAID 1, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
a RAID array.
4 2 0
SATA3
5 3 1
7
7
Pin No. Definition
1 12V
1
2 G
3 R
4 B
Connect one end of the RGB LED strip extension cable to the header
and the other end to your RGB LED strip. The black wire (marked with
a triangle on the plug) of the extension cable must be connected to
Pin 1 (12V) of this header. The 12V pin (marked with an arrow) on the
RGB LED
other end of the extension cable must be lined up with the 12V of the
Strip
LED strip. Be careful with the connection orientation of the LED strip;
incorrect connection may lead to the damage of the LED strip.
Pin No. Definition
1
1
- 19 -
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND