Table of Contents
Advertisement
• If the Projector IP Address still does not appear, contact your network
administrator.
• If the RJ45 cables are not properly connected, the Projector IP Address,
Subnet Mask, Default Gateway and DNS Server
sure the cables are properly connected and perform the procedures above again.
• If you need to connect to the projector in its standby mode, set
Standby LAN Control
• If you are in a non-DHCP environment:
1. Repeat steps 1-2 above.
2. Highlight
LAN Settings
3. Contact your ITS administrator for information on the Projector IP Address,
Subnet Mask, Default Gateway, DNS Server
4. Press to select the item you want to modify and press Enter.
5. Press
/
to move the cursor and the press
6. To save the settings, press Enter. If you do not want to save the settings, press
Exit.
7. Press
to highlight Apply and press Enter.
NOTE:
• If the RJ45 cables are not properly connected, the Projector IP Address,
Subnet Mask, Default Gateway, DNS Server
sure the cables are properly connected and perform the procedures above again.
• If you wish to connect to the projector in its standby mode, be sure you
have selected
Default Gateway and DNS Server
On
to
in the
and press
Static IP
and obtained the Projector IP Address,
settings will display 0.0.0.0. Make
ADVANCED
LAN Control Settings
>
/
to select
Static
settings.
/
to enter the value.
settings will display 0.0.0.0. Make
information when the projector is on.
41
menu.
IP.
Subnet Mask,
Advertisement
Table of Contents
