Panasonic HDC-TM80K Owner's Manual page 108

4
Dubbing through operations on the Blu-ray disc recorder or high-
definition (AVCHD) compatible DVD recorder.
≥
/
Do not touch [CHANGE MEDIA] on the screen of the unit during dubbing.
About the screen indication of the unit
≥ When the unit is accessing the SD card, card access icon (
screen or the access lamp is on.
≥
When the unit is accessing the built-in memory, built-in memory access icon (
appears on the unit screen or the access lamp is on.
≥
When the unit is accessing the HDD, HDD access icon (
screen or the HDD access lamp is on.
≥ Be careful not to disconnect the USB cable, AC adaptor or battery while the unit is
accessing the media, as this may result in the loss of recorded content.
≥ Do not use any other USB cables except the supplied one. (Operation is not guaranteed
with any other USB cables.)
≥ When this unit is connected to a Panasonic Blu-ray disc recorder or a DVD recorder using
a USB cable while the unit is turned on, power is also supplied from the connected
equipment to this unit.
≥ For details on dubbing and playback methods, read the operating instructions of the
Blu-ray disc recorder or DVD recorder.
≥ When you connect the unit to a Blu-ray disc recorder, a dubbing operations screen may
appear on the television connected to the Blu-ray disc recorder. In this case as well,
perform the operations of steps 1 to 4.
≥ You cannot change the mode of the unit or turn off the unit while it is connected to a Blu-ray
disc recorder or DVD recorder. Disconnect the USB cable before performing either of these
operations.
≥ If the battery runs down during dubbing, a message will appear. Operate the Blu-ray disc
recorder to cancel the dubbing.
108
VQT3J15
) appears on the unit
) appears on the unit
)