Viewing Pictures From Connected Equipment - Sony KDL-20S4000 Operating Instructions Manual

Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 4)
In analogue mode, press PROG +/-, or the number
buttons, to select the video channel.
For other connected equipment
Press / repeatedly until the correct input
symbol (see below) appears on the screen.
AV1/ AV1,
Audio/video or RGB input signal through the scart
socket / 1 or 2.
source has been connected.
AV3:
Component input signal through the Y, P
sockets / 3, and audio input signal through the
L, R sockets / 3.
AV4/ AV4:
Video input signal through the video socket
audio input signal through the L (MONO), R audio
sockets 4. appears only if the equipment is
connected to the S video socket
video socket 4, and S video input signal is input
through the S video socket
5:
RGB input signal through the PC connectors
audio input signal through the socket
AV6:
Digital audio/video signal is input through the HDMI IN
6 socket. Audio input signal is analogue only if the
equipment has been connected using the DVI and audio
out socket.
Additional operations
To Do this
Return to the normal Press DIGITAL or ANALOG.
TV operation
16
GB
AV2/ AV2:
appears only if an RGB
/C , P /C
B B R
4, and
4 instead of the
4.
5, and
.
To
Access the Input
signal index table
R
Do this
Press to access the Input signal
index table. (Then, only in
g
analogue mode, press .) To
select an input source, press
then press .
F f
/ ,