Table of Contents
Advertisement
Available languages
Available languages
Checking error messages (cont.)
Message
The display shows:
y The washer has detected an out of balance
The washer is adding
load.
water to redistribute
the load for optimal
performance. No action
is required.
The display shows:
y If the uE rebalance (see above) is not
successful, this error will be displayed.
OUT OF BALANCE
LOAD (UE)
y The load is too small.
y Heavy articles are mixed with lighter items.
y The load is out of balance.
The display shows:
y Thermistor error
TEMPERATURE
SENSOR ERROR
(tE)
The display shows:
y The water level sensor is not working
correctly.
WATER SENSOR
ERROR (PE)
The display shows:
y Thermal overload protection circuit in the
motor has been tripped.
DRIVE MOTOR
ERROR (LE)
Possible Causes
Solutions
y If the washer detects a load that is too far out of
balance to spin, it will display this code while it is
attempting to rebalance the load. The washer will add
water and try to redistribute the load automatically.
This display is for your information only, and no action
is required.
y The automatic attempt to rebalance the load was not
successful. The cycle has been paused to allow the
load to be manually adjusted.
y Small loads may need additional items to be added to
allow the washer to balance the loads.
y The load may have heavy items loaded with lighter
items. Always try to wash articles of somewhat similar
weight to allow the washer to evenly distribute the
weight of the load for spinning.
y Manually redistribute the load if articles have become
tangled preventing the automatic distribution from
working properly.
y Unplug the washer and call for service.
y Close the water taps, unplug the washer, and call for
service.
y Allow the washer to stand for 30 minutes to allow the
motor to cool; then restart the cycle. If the LE error
code still appears, unplug the washer and call
for service.
39
TROUBLESHOOTING
Advertisement
Table of Contents
