Section 200-Receiving Your Equipment; Ystem Omponents; S Responsibility - Farr Gold Series Installation, Operation And Maintenance Manual

SECTION 200-RECEIVING YOUR EQUIPMENT

200.1 The Purchaser's Responsibility
A visual inspection of your equipment should be performed before it is removed from the truck. Dents,
scratches and other damage should be noted and photographed. The structural integrity of the housing
will be adversely affected by large dents. Farr should immediately be notified of any structural damage to
your equipment. It is the purchaser's responsibility to file shortage reports and damage claims
with the carrier and your Farr representative. The carrier is responsible for any damage to the
equipment while it is in transit unless specific arrangements are made otherwise.
The Gold Series dust collector is shipped disassembled and must be reassembled by installation
personnel. Unit assembly, with the exception of the electrical and air connections, can usually be
accomplished by anyone with a basic understanding of common hand tools.
Besides a common set of hand tools, a crane, fork-lift and/or chain-fall will be required to position the fan
and motor on top of the unit clean-air plenum and lift heavier components into position.
Farr must rely on the skill and expertise of its customers and the customer's installation
contractor to ensure that all electrical connections are made correctly and air connections and
regulation devices are installed and operating properly.
200.2 System Components
Your Gold Series dust collection system may consist of one or all of the following components:
1. Filter Module
2. Hopper Section(s)
3. Fan
4. Support Legs
5. Cross Braces
6. Assembly Hardware
7. Motor Starter
8. Maintenance Platform
9. Maintenance Ladder
10. Rotary Airlock
11. Screw Conveyor(s)
12. Slide Gate Kit(s)
Access Platform
Remote Mount
Fan
Rotary Airlock
Support Legs
13. Discharge Drum(s)
14. Manual Cleaning Control
15. Automatic Timer Control
16. Fan silencer
Filter Module –
Cartridges are factory
installed. Hardware is
located inside inlet
Figure 200.2 Gold Series Shipment
Hopper
8