Section 300-Installation Of Your Equipment - Farr Gold Series Installation, Operation And Maintenance Manual

SECTION 300-INSTALLATION OF YOUR EQUIPMENT

Table 300.1: Gold Series Assembly Tools
The following items may be required to install your equipment depending on configuration and installation
requirements:
Only trained, authorized personnel should be permitted to service or maintain electrical or safety
components. It is the buyers/installers responsibility to ensure that all applicable electrical and
safety codes are met.
DESCRIPTION
1 SAE Socket Set
2 Common Screwdriver
3 Phillips Screwdriver
4 Electric Drill or Impact Wrench
5 Hammer Drill
6 Masonry Bit
7 Hammer
8 Pliers
9 Wire Cutters
10 Wire Nuts
11 Electrical Tape
12 Extension Cord
13 Conduit
14 ¾" or larger black iron pipe or equivalent
15 Fittings for items 13 & 14
16 Thread Sealant
17 Alignment Punch
18 Forklift or Overhead Hoist
19 Electrical Cable (3 PH 230/460 VAC 10 HP)
20 Electrical Cable (1 PH 120/240 VAC)
21 Wedge anchors or equivalent suitable for the application
22 230/460VAC, 3 Ph, 60Hz Electric Motor Starter *
23 Transit or Carpenters Level
INTENDED USE
General tightening of fasteners
Electrical connections
Electrical connections
Installation of self-tapping screws and fasteners
Anchoring to floor
Anchoring to floor
Installing anchors
General use
Electrical connections
Electrical connections
Electrical connections
General use
Electrical connections
Compressed air connections
Compressed air and electrical connections
Compressed air connections
Aligning holes
Moving and positioning components
Fan electrical connections
Control and lighting electrical connections
Anchoring to floor
Ventilation Fan * (If not supplied with unit)
Leveling Unit
10