Advertisement
Table of Contents
Easy Install Just a few Quick Steps
We strive to make your installation experience just as pleasant and relaxing as our fountains. Our "Certified Simple" instructions require no
tools and can have you enjoying your fountain within minutes of unpacking. Follow the simple steps below to create your own urban oasis.
Please check the contents of the box before attempting to assemble this product. The full checklist of parts is below. In the unlikely event that any
components are damaged or missing, please contact our customer service hot-line at 407-426-7674.
This product contains small items and plastic bags. Please be aware of the danger to young children.
Often people are tempted to use chlorine or bleach to clean their fountain, this is unfortunately one of the worst things you can do. Chlorine or most
products ending in "ine" or "ide"will ruin a finish quickly and damage your pump. We recommend non-toxic additives like Fountec (an algaecide) and
Protec (a mineral and scale preventative) should you use tap water. These are available through your authorized Bluworld dealer or Bluworld HOMelements.
Parts List
Pump/Light Combo
Glass Pedestal
1
Setup
Use the included peel and stick rubber
pads for protection against marring and
preventing condensation on fine surfaces. Place one pad on
all four corners of the bottom of the base (Fig 1.A).
When considering a location keep in mind the closest
electrical outlet and ease of accessibility for maintenance.
Once you have settled on a location for your Glacier tabletop
fountain position the Base so the electrical access hole is to
the rear.
Your pump is adjustable to vary the flow of water. Make sure
that the pump is set to its lowest flow setting (Fig 1.B).
Tabletop Water Fountain
Base
4 Glass Tier Separators
(2 Extra Separators are included)
Glass Rocks
FIG 1.A
FIG 1.B
3 Glass Tiers
Acrylic Water Tube
(Your Tube size may vary)
Advertisement
Table of Contents
Related Manuals for Bluworld Glacier
Summary of Contents for Bluworld Glacier
- Page 1 “ine” or “ide”will ruin a finish quickly and damage your pump. We recommend non-toxic additives like Fountec (an algaecide) and Protec (a mineral and scale preventative) should you use tap water. These are available through your authorized Bluworld dealer or Bluworld HOMelements.
- Page 2 Assembly Connect the Acrylic Water Tube to the Pump outlet by pushing the outlet on the pump completely into the rubber connector on the Acrylic Water Tube. Make certain it is as close to the Acrylic Water Tube as possible (Fig. 2.A). Place the Pump with Acrylic Water Tube attached in the center of the base.
- Page 3 Bluworld, then the Warranty shall be null and void. The Warranty is in effect for a period of six months beginning from the date of sale to the original retail purchaser and the rights under this Warranty are limited to the original retail purchaser.
Need help?
Do you have a question about the Glacier and is the answer not in the manual?
Questions and answers