Output Signal Adjustment - Cablematic VGA CAT5 Extender User Manual

Output Signal (Video/Audio) Adjustment
 Group (1,2,A)
When one of the output statuses (video/audio) among these groups is
selected, the selected LED will flash indicating the activation; users can turn
the jog wheel by following the clockwise / counterclockwise direction to turn
on/off the video signal or to increase / decrease the volume as the diagram
shown below
The selected audio LED will emit ORANGE light according to the volume
strength. When users turn the jog wheel clockwise, the volume increased
and the ORANGE light strengthened, and vice versa. The diagram below
provides a comparison between the LED light strength and volume of OFF ~
7 levels.
NOTE: The CAT5 audio output signal on the Repeater Unit is not tunable
NOTE: Exit the mode through either one of the operation below.
 Leave the Unit idle (no activity) for 20 seconds.
 Press and Hold the jog wheel for two seconds.

Output Signal Adjustment:

18