Led Selection - Cablematic VGA CAT5 Extender User Manual

LED Selection

Transmitter Unit for 4-Port and 8-Port Models
There is a jog wheel on the top panel of 4/8-port Transmitter Unit, which can be
used to turn on/off the video signal output adjust the volume. A set of LEDs on the
top panel of the Unit is divided into two groups (as the figure shown below), namely,
"Group 1" that includes the video-audio pair LEDs on each of the local output
port and remote (CAT5) output ports 1, 2, 3, 4. (for both 4-Port and
8-Port models)
"Group 2" that includes the video-audio pair LEDs on each of the remote
(CAT5) output ports 5, 6, 7, 8. (available for 8-Port model only)
 Group Selection (for 8-Port model only)
Step 1. Power on the Unit, the LED "Power/EDID Copy" will illuminate GREEN,
and the rest of the LEDs on the Unit will illuminate ORANGE.
Step 2. Connect the source computer to the input port on the Unit, the LED
"Power/EDID Copy" will turn to BLUE indicating that the signal input
is activated and the Unit is ready for configurations.
Step 3. Press and Hold the jog wheel for about 2 seconds, the LEDs on
both groups will flash ORANGE alternatively; then, users can
release the jog wheel to select the desired group.
 Port Status Selection (Video/Audio)
Each output port associates with a pair of video and audio LEDs on the top
panel of the Unit. Within about 20 seconds after one group selected, users
can press the jog wheel once to switch the status port between video/audio.
14
LEDs of Group 1 and
Group 2 on 8-Port
Transmitter