Changing Remote Control Codes; Enter A Code To Operate Some Equipment - Panasonic SA-XR57K Operating Instructions Manual

Changing remote control codes

Two or more Panasonic audio equipment may start
functioning when you use the unit's remote control for
operating the equipment.
Switch the unit's remote control code to
"REMOTE 2 " in such cases.
Use the same code for setting the unit and its remote
control through the following steps.
INPUT SELECTOR
MENU
SETUP
RETURN
SS
Y HDMI
INPUT SELECTOR
TUNE MENU
SETUP ENTER
RETURN
Basic operation
INPUT SELECTOR
Turn to make
a choice.
Press to confirm
ENTER
your choice.
To return to the
MENU
SETUP
previous display/
To cancel
RETURN
Operation on the main unit
1 Enter the setup.
MENU
SETUP
Press and hold for approximately 2 seconds.
RETURN
2 Select and confirm the setting.
3 Select and confirm the setting.
4 Press [-MENU, –SETUP,
RETURN] to select "EXIT "
and press [ENTER].
Operation on the remote control
TUNER
5 Press
BAND
6 Press and
ENTER
simultaneously and hold
them in the position for
approximately 2 seconds.
When you return the remote
control code to "1"
• Operation on the main unit: select "1" in step 3.
• Operation on the remote control: press
[ENTER] and [1] simultaneously and hold
them in the position for approximately 2
seconds or longer in step 6.

Enter a code to operate some equipment

This remote control can operate Panasonic and Technics audio-visual equipment that
has remote control sensors. You may need to change the remote control code.
It can also operate some other brands of televisions, video cassette recorders, and DVD
players. Check the table for the brand and enter the code as follows.
Changing the codes
TV
ENTER
TV
Press and hold the button
corresponding to the equipment.
VOLUME
Enter the first digit.
Enter the second digit.
The remote control outputs the on/off
signal.
If the code is correct, the equipment
turns on or off.
If it doesn't, try entering another code.
• Note that this remote control cannot
operate some equipment and that it may
not be able to perform some operations.
• Re-enter the codes after you change the
batteries.
VCR DVD player
PLAYER
DVD
VCR
ANALOG 6CH
0
0
Code table
23
RQT8549