Batteries For Remote Control; Maintenance And Care - Panasonic CQ-VA70EU Operating Instructions Manual

Batteries for Remote Control
Battery Replacement:
1. Remove the battery holder.
Pull the holder by the Position B while
pushing Position A in the direction indi¬
cated by the arrow.
2. Replace the battery.
Set a new battery properly with the (+)
side up as illustrated.
3. Insert the battery holder.
Push in the holder to the original position.
Remote control
Note on Batteries:
Old batteries must immediately be removed and disposed.
Battery Information:
• Designated Battery: Panasonic Lithium Battery (CR2025)
• Battery Life: 6 months with normal use (in normal room temperature)
-
Caution:
Improper use of batteries may cause overheating, explosion or ignition, resulting in injury or fire.
Battery leakage may cause damage to the unit.
v_
• Do not disassemble or short the batteries. Do not throw the batteries into the fire.
• To avoid the risk of accident, keep the batteries out of reach of children.
Maintenance and Care
Maintenance
Your product is designed and manufactured to ensure a minimum of maintenance. To clean the exterior of
this unit, use a soft cloth to wipe the surface. Do not use benzine, thinner, or any other type of solvent.
Product Service
• This unit should only be serviced by qualified technicians. Service information is not provided for cus¬
tomers.
• Should your units ever require service, refer to the MITO service department listed in the Warranty card
for detail instructions.
Replacing the Fuse
Be sure to use a fuse of the specified rating (3A, 10A) when replacing a blown fuse. Fuses with higher ca¬
pacity ratings, use of any substitute, or connection without a fuse may result in a fire hazard or damage to
the unit. If the replacement fuse fails, consult the MITO service department for detail instructions.
CQ-VA70EU
31