Table of Contents
Advertisement
Error messages
Display
(Scrolling)
(Scrolling)
Specifications
AMPLIFIER SECTION
RMS Output Power of each channel driven
10 % total harmonic distortion
1 kHz Front CH
1 kHz Center CH
100 Hz Subwoofer CH
Total RMS Output Power
Rated minimum sine wave RMS power output
1 % total harmonic distortion (Dolby Digital Mode)
120 Hz - 20 kHz Front CH
120 Hz - 20 kHz Center CH
45 Hz - 120 Hz Subwoofer CH
Total FTC Output Power
Rated minimum sine wave RMS power output
1 % total harmonic distortion (Stereo mode)
120 Hz - 20 kHz Front CH
45 Hz - 120 Hz Subwoofer CH
Total FTC Output Power
Total harmonic distortion
half power at 1 kHz (Front CH)
Input sensitivity
TV, AUX 3
S/N at rated power
BD/DVD, TV, AUX 1, AUX 2
Input impedance
TV, AUX 3
Tone controls
BASS
TREBLE
Digital input/output
HDMI Input
HDMI Output
Optical digital input
Coaxial digital input
This system supports "HDAVI Control 3" function.
Analog input/output
Analog audio input
OPERATING CONDITIONS:
Operating temperature range:
Operating humidity range: 20% to 80% RH (no condensation)
Check point/Cause/Countermeasure
•
Set the same remote control code for this system and remote control.
If "REMOTE 2" is displayed, set remote control code to "2".
If "REMOTE 1" is displayed, set remote control code to "1".
•
The equipment connected by the HDMI cable is not compatible with this
system's copyright protection technology.
•
The system is receiving video signals that are incompatible with it through
HDMI connection. Check the settings of the connected equipment.
•
A problem has occurred with the HDMI connection. Try the following to correct
the problem. Consult your dealer if the error code remains on the display.
― Turn the connected equipment off and on again.
― Disconnect the HDMI cable then reconnect it.
― Do not connect more than 2 equipment in series to the output of this system.
•
You cannot use Dolby Virtual Speaker, Dolby Pro Logic
sounds.
•
You cannot use Dolby Virtual Speaker, Dolby Pro Logic
PCM signals with sampling frequency over 48 kHz.
•
SFC is not available for multi-channel LPCM signal.
70 W per channel (4 Ω)
70 W per channel (4 Ω)
90 W per channel (3 Ω)
300 W
45 W per channel (4 Ω)
43 W per channel (4 Ω)
57 W per channel (3 Ω)
190 W
47 W per channel (4 Ω)
57 W per channel (3 Ω)
151 W
0.5 % (4 Ω)
450 mV, IHF'66
80 dB
47 kΩ
50 Hz, +6 dB to -6 dB
20 kHz, +6 dB to -6 dB
1
1
2
1
2
0°C to +40°C
(
+32°F to +104°F
)
GENERAL
Power supply
Power consumption
Main set
Standby (HDMI ON)
Standby (HDMI OFF)
SPEAKER SYSTEM
FRONT (L/R)
1-Way 1 Speaker System (Bass Reflect)
6.5 cm (2
Input power (IEC)
Output sound pressure level
Frequency range
CENTER
1-Way 1 Speaker System (Bass Reflect)
6.5 cm (2
Input power (IEC)
Output sound pressure level
Frequency range
SUBWOOFER
1-Way 2 Speaker System (Bass Reflect)
13 cm (5
Input power (IEC)
Output sound pressure level
Frequency range
RACK SYSTEM
(INCLUDING SPEAKER)
Dimensions (W x H x D)
Mass
Mass is a Completed (AMP, Speaker Unit inc)
Maximum Loading Weight
Rating with low-cut filter equipped amplifier
Note
1. Specifications are subject to change without notice.
2. Total harmonic distortion is measured by the digital spectrum
analyser.
Pages
34
—
—
—
—
—
32
and SFC for dual
26
and SFC effect with
26
AC 120 V, 60 Hz
68 W
0.7 W
0.3 W
1
/
"
) Cone Type Full Range x1
2
70 W (Max/4Ω)
79 dB/W (1.0 m)
80 Hz - 25 kHz (-16 dB)
95 Hz - 22 kHz (-10 dB)
1
) Cone Type Full Range x1
/
"
2
70 W (Max/4Ω)
79 dB/W (1.0 m)
80 Hz - 25 kHz (-16 dB)
95 Hz - 22 kHz (-10 dB)
1
) Cone Type Woofer x2
/
"
8
90 W (Max/3Ω)
82 dB/W (1.0 m)
35 Hz - 600 Hz (-16 dB)
42 Hz - 500 Hz (-10 dB)
1300 mm x 444 mm x 458 mm
1
15
1
(51
/
" x 17
/
" x 18
/
8
32
approx. 50kg
(110.2 Ibs)
80 kg
(176.4 Ibs)
")
32
35
RQTX0165
Advertisement
Table of Contents
