3.16
LED
There are 4x LEDs at the FLEETPC-ARM-300 front panel:
When DC power is applied, PWR LED is on
3G LED mode is in below table:
Mode
Operating Status
1
No service/Restricted
service
2
Register to the network
3
Dial-up successfully
When FLEETPC-ARM-300 is connected to 3G/LTE network, the
LED is ON. In searching 3G/LTE network, the LED keeps
blinking.
LED1, LED2 are connected to below iMX6 pads directly and can be turned on/off by
software.
LED name
iMX6 Ball
LED1
LED2
// Linux commands to turn on/off LED1 or LED2:
# echo 1 > /sys/class/leds/led1/brightness
# echo 0 > /sys/class/leds/led1/brightness
# echo 1 > /sys/class/leds/led2/brightness
# echo 0 > /sys/class/leds/led2/brightness
All manuals and user guides at all-guides.com
LED2
LED1 PWR
ON(0.1s) - OFF(0.1s) - ON(0.1s) - OFF(1.7s)
2-second cycle
ON(0.1s) - OFF (1.9s)
2-second cycle
ON
iMX6 Pad Name
R7
GPIO_3
W5
KEY_COL0
Page
FLEETPC-ARM-300 Series
3G
LED ON/OFF
iMX6 Signal
GPIO1_IO03
GPIO4_IO06
// led1 off
// led1 on
// led2 off
// led2 on
41