Table of Contents
Advertisement
General
[MUTE] (Mute/attenuation)
[VOLUME]
(SBC-SW)
[SOURCE]
(PWR: Power)
Point the remote control unit at the remote control signal sensor.
Power
Turn your car's ignition key
A C C
to the ACC or ON position.
O N
ON:
Press [SOURCE] (PWR).
OFF:
Press [SOURCE] (PWR) again and hold for
more than 1 second.
Press [SOURCE] (POWER) again and hold
for more than 1 second.
Note:
≥ After turning off the ignition key, a security
message is displayed, and the panel removable
alarm that reminds you to take the panel is
activated.
(When security function is set to on, page 38)
Demonstration:
When the power is switched on for the fi rst time,
a demonstration appears on the display.
Press [DISP] (display) to change to regular
mode.
Note:
≥ To display the demonstration again, press and
hold [SOURCE] for more than 4 seconds when
turning power on.
10
CQ-CB9900U
[MENU] (DIM)
[DISP] (Display)
Source
Press [SOURCE] to change the source.
Radio (page 14)
CD player (page 19)
When a CD is in the player.
or
MP3 player (page 22)
When a MP3 data disc is in
the player.
or
WMA player (page 22)
When a WMA data disc is
in the player.
CD changer control (page 28)
When an optional CD changer
is connected.
AUX (page 57)
[SOURCE]
POWER
MENU
(Power/source)
[VOL "]
SOURCE
SEL
NUMBER
VOL
[MUTE]
[VOL #]
#
MUTE
(Mute/attenuation)
(Volume)
1
2
3
(SBC-SW)
RAND
SCAN
REP
4
5
6
7
8
9
[DISP]
0
BAND
DISP
SET
(Display)
Car Audio
Volume
[VOL "]: Up
[VOL #]: Down
Up
Down
Setting range: 0 to 40
(default: 18)
Note:
≥ The volume level can be set independently for
each source (for radio, one volume setting for
AM, one volume setting for all FMs).
Mute/Attenuation
ON:
Press [MUTE].
OFF:
Press [MUTE] again.
You can select mute or attenuation (page 38).
No sounds. (default)
Decrease the volume by 10 steps.
Dimmer
Press and hold [MENU] (DIM) for more than
2 seconds to change dimmer level setting as
follows.
Brighter (default)
Medium
Darker
Rear Speakers as Sub-Woofers
(Super Bass Control Subwoofer/SBC-SW)
You can utilize the rear speaker connected to the
built-in amplifi er as Sub-Woofers that output only
bass. (Default: OFF)
Press and hold [MUTE] (SBC-SW) for more than
2 seconds.
OFF (default)
ON
lights.
Note:
≥ When ON has been selected, the settings resulting
from the adjustments performed at the subwoofer
level and subwoofer low pass fi lter settings are
refl ected in the output.
≥ Depending on the speakers used and the type of
music played, it may not be possible to achieve a
satisfactory effect.
CQ-CB9900U
11
Advertisement
Table of Contents
