Attach the camera bracket to a glass or painted surface on the vehicle
body.
Form the camera bracket to
fi t the form of the mounting
surface. (Do not remove the
backing paper)
Camera bracket
Mount the camera body onto the camera bracket.
Bolt with washer
Hexagon wrench
Rear view camera
Side with logo
uppermost
Adjust the camera angle so that the fender or the rear edge of the vehicle
appears at the bottom of the monitor.
Use the Hexagon wrench
to loosen the bolts, then
adjust the camera angle.
(After adjusting, tighten the
bolts securely.)
Peel the backing paper and press the camera
bracket fi rmly onto the surface.
The screw holes to use, and the possible angle
adjustment, vary according to the mounting
position.
Direction
of forward
90°
motion
Mount on the screw holes
on the side opposite
the direction of forward
motion.
Fender or the rear edge of
the vehicle
Do not touch the bonding
surface with your hands.
Do not re-attach the
adhesive.
Side view
Logo
Direction
45°
of forward
motion
Mount on the screw holes
below the camera.
Camera fi eld of view
Approx. 103°
Approx. 134°
Logo
0°
90°