Page 1
Hailo TOPlift CCV Supplement to the operating instructions. Valid only in connection with the orig- inal operating instructions. Read the instructions prior to performing any task!
The CCV (cold climate version) enables operation of the service lift to temperatures as low as -35°C. This manual describes the distinctive features and enhancements of the Hailo TOPLift CCV and is valid only together with the original operating instructions of the Hailo TOPlift L.
Page 5
Mechanical components must be checked for proper functioning, as well as for wear or damage, and replaced if necessary. A non-scheduled test is required if components of the service lift are overloaded through improper use. • TOPlift CCV •...
Introduction General instructions The Hailo TOPlift CCV is an enhanced version of the Hailo TOPlift L. The service lift is equipped with additional functions and components. These are described below. The Hailo TOPlift CCV can be operated at temperatures as low as -35°C.
Only with faultlessly functioning components and features can safety be guaran- teed. Should you have any questions, please feel free to contact us at Hailo Wind Systems. Switch cabinet heater The switch cabinet is equipped with its own heater. This ensures that the components in the switch cabinet also function reliably at lower temperatures.
Page 8
Lock mechanism of shutter door The Hailo TOPlift CCV is equipped with a special shutter door lock [1]. This safety device prevents the shutter door from opening during ascent or descent as well as when stopped between plat- forms (to avoid danger of falling).
The shutter door can now be opened. The emergency release must be reset in order to restore the equipment to operational status. To do this, pull the button back out to its starting position. • TOPlift CCV •...
Page 10
DANGER! Caution, danger of falling! If you are not secured with your personal protective equipment, you could fall! Always secure yourself in a suitable manner against falls by employing your personal protective equipment (PPE). • TOPlift CCV •...
Maintenance work may only be carried out by the following personnel: – Authorised Hailo employees – Authorised employees of your local Hailo service center – Authorised employees of your company who have been suitably trained and certified by Hailo (qualified persons) A scheduled inspection of the drive components must be performed annually.
Page 12
If a loose screw connection is found on a system component, all connection screws on this component must be tightened or, if needed, replaced. Check rollers and roller bearings on the system components for sluggishness and damage. Damaged or worn bearings must be replaced. • TOPlift CCV •...
Page 13
Check of the red and green indicator lights on the front of the switch cabinet Electrician Check and, if necessary, adjustment of the correct temperature default according to the circuit diagram. Electrician Functioning of the shutter door lock Qualified person • TOPlift CCV •...