Table of Contents
Advertisement
6
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
To reduce the risk of fire, electric shock, or personal injury when using your product, basic safety
precautions should be followed, including the following.
CAUTION
Installation
•
The refrigerator must be properly installed in accordance with the Installer Instructions that
were taped to the front of the refrigerator.
•
Be careful when you unpack and install the refrigerator. Immediately dispose of packing
materials (plastic) out of reach of children.
Use
•
Close the door carefully when children are around.
•
Keep fingers out of pinch point areas; clearances between the doors and cabinets are
necessarily small. Be careful closing doors when children are in the area.
•
If you store food properly, beware that it may fall and cause injury.
Maintenance
•
Do not use strong detergents like wax or thinners for cleaning. Clean with a soft fabric.
•
Wipe foreign objects (dust, water, etc) off the prongs of the power plug and contact areas regularly.
WARNING
Keep ventilation openings, in the appliance enclosure or in the built-in structure,clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
Do not damage the refrigerant circuit.
Do not use electrical appliances inside the food storage compartment of the
appliance, unless they are of the type recommended by the manufacturer.
The refrigerant and insulation blowing gas used in the appliance require
specialdisposal procedures. When disposal, please consult with services
agent or asimilarly qualified person.
This appliance contains a small amount of isobutane refrigerant (R600a),natural gas
with high environmental compatibility, but it is also combustible.When transporting and
installing the appliance, care should be taken to ensure that no parts of the refrigerating
circuit are damaged. Refrigerant squirting out of the pipes could ignite or cause an eye
injury.if a leak is detected, avoid any naked flames or potential sources of ignition and
air the room in which the appliance is standing for several minutes.
In order to avoid the creation of a flammable gas air mixture if a leak in the refrigerating
circuit occurs, the size of the room in which the appliance may be sited depends on
the amount of refrigerant used. The room must be 1m in size for every 8g of R600a
refrigerant inside the appliance. The amount of refrigerant in your particular appliance
is shown on the identification plate inside the appliance. Never start up an appliance
showing any signs of damage. If in doubt, consult your dealer.
SAVE THESE INSTUCTIONS
2
Advertisement
Table of Contents
