Vega Absolute SI-13 User Manual page 11

Vega SI-13 / User Manual
Equipment with NAMUR pulse output is not supported
Polarity effects only "open collector" circuits.
To reset all readings from the pulse inputs accumulated in the device memory you
need to switch the device to the "Storage" mode by holding the start button pressed
(min. 5 seconds).
Pulse inputs can be configured for work in the "Security" mode via the "Vega LoRaWAN
Configurator" application. In this mode, the device does not count pulses at the "Security"
input, but only monitors its status. Should the "Security" input trigger, the device is activated
and sends an alarm message to the network.
The maximum possible frequency of sending alarm packets is one per 1 second.
Revision № 14 of 06 August 2021
11