Pioneer VSX-1127 Operating Instructions Manual page 85

12
ZONE Setup
VSX-1127 only
When making multi-zone connections using the AUDIO ZONE 2 OUT terminals and performing playback in Zone
2, you can set whether to adjust the Zone 2 volume on the receiver or to fix it to a specific volume (–40 dB Fixed
or 0 dB Fixed). This is set to Variable upon shipment from the factory, allowing the volume to be adjusted on the
receiver. If you would like to adjust the volume from the connected amplifier, make the setting below.
! This setting is not possible if multi-zone settings have been made using the speaker terminals and
Speaker System is set to anything other than ZONE 2. In this case, adjust the volume for the sub zones on the
receiver.
CAUTION
! Note that when Volume Level is set to 0 dB Fixed, the audio output from the AUDIO ZONE 2 OUT terminals
is set to the maximum. Also, depending on the volume setting on the connected amplifier, large volumes may
be produced even when Volume Level is set to –40 dB Fixed.
1 Select 'ZONE Setup' from the Other Setup menu.
2 Select 'ZONE 2', then press ENTER.
3 Select the Volume Level setting you want.
! Variable (default) – The Zone 2 volume is adjusted from the receiver.
! –40 dB Fixed/0 dB Fixed – The Zone 2 volume level output from the receiver is fixed to the value set here.
4 When you're finished, press RETURN.
You will return to the Other Setup menu.
85
The System Setup and Other Setup menus