Error Messages - Panasonic DMR-E55S Operating Instructions Manual

Error messages

On the television
Cannot finish recording
completely.
Cannot play.
Cannot record on the disc.
Unable to format.
Please check the disc.
Cannot record. Disc is full.
Cannot record. Maximum
number of titles exceeded.
Error has occurred. Please
press ENTER.
No disc
Please change the disc.
This is a non-recordable disc.
This disc is not formatted
properly.
$
On the unit's display
CHK REMOTE
("∑" stands for a number.)
HARD ERR
NO READ
PROG FULL
SELF CHECK
UNSUPPORT
U14
U99
RQT7301
42
≥The program was copy-protected.
≥The disc may be full.
≥You inserted an incompatible disc (Discs recorded in PAL video etc.).
≥The disc may be dirty or scratched.
≥Create space by erasing any unnecessary titles. [RAM]
≥Use a new disc. [RAM] [DVD-R]
≥Press [ENTER] to start recovery process. You cannot operate the unit while it is recovering
("SELF CHECK" appears on the unit's display).
≥The disc may be upside down.
≥There may be a problem with the disc. Press [< OPEN/CLOSE] to remove it and check it
for scratches or dirt. (The unit turns off automatically after you open the tray.)
≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R.
≥You inserted an unformatted DVD-RAM. Format the disc with this unit.
≥The operation is prohibited by the unit or disc.
≥The remote control and main unit are using different codes. Change the code on the
remote control.
≥If there is no change after turning the unit on and off, consult the dealer where the unit was
purchased.
≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.
≥You have used a DVD-RAM/PD lens cleaner and it has finished. Press [< OPEN/CLOSE]
to eject the disc.
≥There are already 16 timer programs. Delete unnecessary timer programs.
≥There was a power failure or the AC plug was disconnected while the unit was on. The unit
is carrying out its recovery process. Wait until the message disappears.
≥You have inserted a disc the unit cannot play or record on.
≥The unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when installing the unit. Do not block the cooling fan
on the rear of the unit.
≥The unit fails to operate properly. Press [POWER Í/I] on the main unit to switch the unit to
standby. Now press [POWER Í/I] on the main unit again to turn the unit on.
Press and hold [ENTER] and the indicated number button at
the same time for more than 2 seconds.
Page
—
—
—
15
24, 29, 33
—
—
—
15
—
33
—
14
—
15
—
21
—
15
—
—