Table of Contents
Advertisement
Accessories
Cooking container, solid, GN
deep (baking tray)
Cooking container, solid, GN
deep
Cooking container, perforated, GN
40 mm deep
Porcelain cooking container, solid, GN
Porcelain cooking container, solid, GN
Wire rack
Cleaning sponge
Descaler
Honeycomb microfibre cloth
Before using for the first time
In this section you will find out which steps are required before
using the appliance for the first time:
Setting the clock
■
Setting the water hardness range
■
Starting the appliance for the first time
■
Cleaning the accessories before use
■
Setting the clock
After the power has been connected, the
light up in the display. Set the clock.
Press the
button.
0
1.
The time
:
is shown in the display.
‚ƒ
‹‹
Use the
or
button to set the clock.
@
A
2.
After a few seconds, the time which has been set is applied.
Setting the water hardness range
Descale your appliance regularly. This is the only way to
prevent damage.
Your appliance automatically displays when it needs descaling.
It has been preset to the "medium" water hardness range.
Change the value if your water is softer or harder.
You can enquire about the water hardness with your water
supplier.
If your water is very hard, we recommend that you use softened
water.
You can only dispense with descaling completely if you
exclusively use softened water. If this is the case, change the
water hardness to "softened".
You can change the water hardness range in the basic settings
when the appliance is switched off.
If required, turn the operating mode selector to
1.
the appliance.
Press and hold the
0
button until
2.
display.
Press the
button repeatedly until
0
3.
("moderate" water hardness range).
8
Order no.
HZ36D542
Z
, 28 mm
HZ36D513
, 40 mm
Y
HZ36D513G
,
Y
HZ36D533P
Z
HZ36D513P
Y
HZ36DR4
623 653
311 138
460 770
symbol and
0
Û
to switch off
™‹ ƒ
appears in the
appears
™† ƒ
Press the
or
@
4.
Possible values:
™† ‹
™† ‚
™† ƒ
™† „
™† ...
:
‹
‹‹
Press and hold the
5.
The change is saved.
Before first use
Before first use, heat the empty appliance for 20 minutes at
100 °C using Steam
during this time. The appliance is automatically calibrated (see
section: Automatic calibration).
Fill and insert the water tank (see section: Filling the water
1.
tank).
Before using for the first time, moisten the seal in the tank
cover with a little water.
Turn the operating mode selector to Steam
2.
Turn the temperature selector to 100 °C.
3.
Press the
J
|
4.
The appliance heats up to 100 °C. The cooking time
(20 minutes) does not start to count down until the set
temperature has been reached. Do not open the appliance
door during this time.
The cooking operation ends automatically and an audible
signal sounds.
To switch off the appliance, turn the operating mode and
5.
temperature selectors to
Leave the appliance door ajar until the appliance has cooled
down.
Cleaning the accessories before use
Using soapy water and a soft cloth, clean the accessories
thoroughly before first use.
button to change the water hardness range.
A
softened
soft
moderate
hard
very hard
button to exit basic settings.
0
. Do not open the appliance door
é
"
button.
.
Û
-
I
II
III
IV
.
é
Advertisement
Table of Contents
