Installation; Cable Connection - Panasonic PT-60LCX63 Operating Instructions Manual

Installation

Notes on con nec tions
• Turn off the power supply for all com po nents before making any connections.
• If the cables necessary for connecting a component to the system are not included with the component or available as an
option, you may need to fashion a cable to suit the component concerned.
• Read the instruction manual for each system component care ful ly before connecting it.
• If there is a lot of jitter in the video signal input from the video source, the picture on the screen may fl icker. In this case, it will
be necessary to connect a TBC (time base corrector).
CAUTION
When using "Nut type" RF coaxial cables, tighten with fi ngers only. Overtightening may damage terminals.
Connecting the Antenna / Cable to the RF IN Terminal
For proper reception of analog or digital cable channels, a cable service connection is required.

Cable Connection

Connect the cable supplied by your local cable company to ANTENNA (A) connection on back of unit. Select Cable
mode and ANTENNA (A) in SET UP menu under Program Channel.
TERMINAL ON THE
BACK OF THE
CABLE BOX
In from cable
In from cable
Note:
Cable Mode is preset at the factory. Antenna users must change to ANTENNA Mode for ANTENNA (A) in the Setup menu. If you
have both Cable and Antenna, the Cable must be connected to ANT A.
14
For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at: http://www.panasonic.com/contactinfo
CABLE BOX
Connect the cable from the
antenna or cable system to the
ANTENNA (A) terminal on
the back of the Device Display.
Or