Supplied Accessories; Remote Control Battery Installation; How To Remove The Tv-Stand - Panasonic TC-26LX50 Operating Instructions Manual

SUPPLIED ACCESSORIES

Remote control battery installation

Requires two AA batteries.
1. Open the battery cover.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environmentally friendly manner.
1. Always use new batteries when replacing the old set.
2. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
3. Battery replacement is necessary when remote control acts sporadically or fails to operate this unit.
Notes:
• Do not drop, apply shock to or step on the remote control.
• Do not spill water on the remote control.
• Do not place objects between the remote control and remote control receiver.
• Do not use remote controls for other equipment at the same time.
• If the TV does not operate even when using the remote control from a close range, it is time to replace
the batteries.

How to remove the TV-Stand

Follow the procedure below when the TV-Stand needs to be removed for wall-hanging.
Place the TV face down
1
on a foam mat or a thick
soft cloth to prevent
damage to the panel.
Foam mat or thick soft
cloth
Remove the cable cover. (see page 7)
2
Remove screws. (at 4 points)
3
6
2. Install the batteries.
Note the correct polarity (+ and -).
Two AA size
Carefully pull out the TV-Stand.
4
Reinstall the cable cover.
5
(see page 7)
3. Replace the cover.