Power Connection; Basic Functions - Maxwell MW-4001 Instruction Manual

-There are foreign objects inside the unit.
-If the unit has been exposed to rain or water.
-If the unit does not operate normally.
-If the unit fell down or was damaged in any other
way.
Cleaning
Unplug this unit from the wall outlet before clean-
ing. Use a damp soft cloth for cleaning. Do not
use liquid cleaners or aerosol cleaners.
Cleaning disc
-Do not use cracked or deformed discs, it can
damage the unit.
-Hold the disc only by the edges. Do not touch
the operating surface of a disc. Dust, scratches
or fingerprints on the surface may lead to a fail-
ure of the unit.
-Protect the disc from direct sunlight; heat
sources, high temperature and moisture.
-After usage, put the discs in the case for stor-
age. Wipe the surface of the discs with a soft
cloth from the center to the edges periodi-
cally.
Before operation
Unpack the unit. Open the lid (7) and eject the
protective insert, close the lid (7).
Remove all advertising labels and stickers, which
prevent the unit from normal operation, from the
upper and front part of the unit.
DESCRIPTION
1. Earphones jack (3,5mm
2. FUNCTION switch (CD / OFF / RADIO)
3. VOLUME control
4. PROG +10 button
5. STOP button
6. LCD-display
7. CD compartment lid
8. Telescopic FM – antenna
9. FM ST indicator
10. Radio tuning scale
11. ►║ PLAY/PAUSE
12. REP button
13. TUNING knob
14. BAND switch (AM / FM /FM ST)
15. / button
16. Speakers
17. Jack for connecting the power cord
18. Battery compartment lid
4001_NEW.indd 5 4001_NEW.indd 5
).
5

POWER CONNECTION

Line supply
Before connecting the unit, make sure that your
home electricity supply corresponds to the volt-
age specified on the unit.
- To connect the unit, insert one end of the pow-
er cord in the jack (17), and the power plug into
the socket.
- Set the (2) FUNCTION switch to the CD or RA-
DIO position.
- To switch off the unit set the (2) FUNCTION
switch to the OFF position.
Battery supply
-Disconnect the player.
-Open the battery compartment lid (18).
-Insert 8 batteries of "C", "LR14", UM 2" type 1,5
V (not supplied) into the battery compartment
following the polarity.
-Close the battery compartment lid.
Attention!
- Do not use batteries of different types togeth-
er, for instance alkaline and manganesian-zink
ones. Use only batteries of the same unit.
- Do not use old and new batteries together when
replacing the batteries.
- With unstable operation of the unit, check the
batteries and replace them if necessary.
- Take the batteries out if you are not going to use
the unit for a long time.
- Improper usage of the batteries can lead to
electrolyte leakage and damaging of the unit.
Note: When the unit is in the standby mode, it still
consumes power, to switch off the unit completely
disconnect the power cord from the socket.
Connecting the earphones
To listen to the player via the earphones (not
supplied) connect them to the (1) PHONES jack.
Set the desired volume level using the (3) VOL-
UME control. Playback from the speakers will
switch off automatically when the earphones are
connected.
Attention! Do not listen to music too loud via
the earphones. To avoid decline of hearing while
listening to the unit via the earphones, do not
make the volume too high, experts do recom-
mend listening to the unit at high volume for a
long time.

BASIC FUNCTIONS

Adjusting volume level
Use the VOLUME (3) control to adjust the desired
volume level.
ENGLISH
15.07.2011 10:54:21 15.07.2011 10:54:21