DO NOT hold the cover.
DO NOT hold the ball
screw spline shaft.
The above figure shows the
TH550A-T
After the installation, remove the clamp and eyebolt used for transport.
•
When lifting up the robot by workers, hold the specified locations by hand,
as shown in Fig. 2.5. If the arm 2, cover, or ball screw spline shaft is held
by hand, an unusually large force is exerted, resulting in a malfunction.
•
When carrying the robot by workers, take careful precautions to prevent
their hand or leg from being caught in the robot.
•
The work should be performed by two (2) or more workers.
CEILING TYPE SPECIFICATIONS MANUAL
Fig. 2.5 Robot handling areas
!
CAUTION
– 24 –
DO NOT hold the duct.
Handling areas
STE 80870