Advertisement
L
E
D
M
O
N
I
T
O
R
User's Guide Book
L
E
D
M
O
N
I
T
O
R
INFORMATION TO THE USER
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
WARNING
The manufacturer is not responsible for any Radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user's authority to operate the equipment."
Power indicator is off
- The power cord is
properly connected?
and no picture
- Check the power
button of monitor
No picture even though
- Check the signal cable
is connected properly.
the power LED is on.
Screen position is not
- Check the screen size
and position
collect.
Screen is too bright or
- Check the brightness
of the monitor
dark
Screen is not clear.
- The frequency sets up
properly?
Focus is bad and noise
occur.
- Connect the power
cord properly.
- Turn on the monitor
- Connect the signal cable
properly
- Press AUTO button on
OSD menu
- Adjust the brightness by
PC system
- Adjust the frequency by
PC.
Advertisement
